Star SP700 Series - Adjusting the Paper Feed Path

3. Adjusting the Paper Feed Path
Insert a thickness gauge [3] between the tear bar base [1]
and cutter guide [2] to measure the gap.
1.
[ 3 ]
[ 2 ]
[ 1 ]
Fig. 3-1 Measuring the Gap
[ 2 ]
[ 1 ]
[ 4 ]
[ 4 ]
Fig. 3-2 Where to Measure the Gap
e standard value for the gap is 0.3 to 0.5 mm. If the
adjustment is within that range, tighten the screws [4]
you loosened or removed.
2.
- 5 -