– 14 –
ENGLISH
Note 2: When using paper with a thick-
ness which does not require the use of
the tension bar (100
µ
m paper thick-
ness
150
µ
m), remove the tension bar
unit by removing the clips at both ends
of the bar with a flat head screwdriver.
Then, lower the right and left adjust-
ment levers by unhooking them with a
flat head screwdriver first, then lower-
ing them to the proper position.
Ordinarily, your dealer should have
already done these procedures.
Note: When using a paper roll with an
82.5 mm width, be sure to remove the
paper roll holder.
Paper roll holder
To Next Page
Loading...
