Starline A96 - Page 21

To adjust the motion sensor sensitivity level, select the sixth item in the settings menu. Then, using
buttons
icon-short-2.png
Image not found or type unknown
and
icon-short-3.png
Image not found or type unknown
, set the desired value from 0 to 30.
0 — sensor disabled, 30 — maximum sensitivity level.
Setting Tilt Sensor Sensitivity
To adjust the tilt sensor sensitivity level, select the seventh item in the settings menu. Then, using
buttons
icon-short-2.png
Image not found or type unknown
and
icon-short-3.png
Image not found or type unknown
, set the desired value from 0 to 30.
0 — sensor disabled, 30 — maximum sensitivity level.
Setting Warning Shock Sensor Sensitivity
To adjust the pre-warning shock sensor sensitivity level, select the eighth item in the settings
menu. Then, using buttons
icon-short-2.png
Image not found or type unknown
and
icon-short-3.png
Image not found or type unknown
, set the desired value
from 1 to 30.
0 — sensor disabled, 30 — maximum sensitivity level.
The selected pre-warning shock sensor sensitivity value must be greater than the alarm shock
sensor sensitivity value.
Setting Alarm Shock Sensor Sensitivity
To adjust the alarm shock sensor sensitivity level, select the ninth item in the settings menu. Then,
using buttons
icon-short-2.png
Image not found or type unknown
and
icon-short-3.png
Image not found or type unknown
, set the desired value from 0 to 29.
0 — sensor disabled, 29 — maximum sensitivity level.
The selected alarm shock sensor sensitivity value must be lower than the pre-warning shock sensor
sensitivity value.
Setting Mark Loss Zone Range
To set the range of the mark loss zone, select the tenth item in the settings menu. Then, using
buttons
icon-short-2.png
Image not found or type unknown
and
icon-short-3.png
Image not found or type unknown
, set the desired value from 3 to 10.
3 — minimum range, 10 — maximum range.
The mark loss zone range should be greater than the mark detection zone range.
Setting Mark Detection Zone Range
Ensure that the set mark loss zone range is sufficient from all sides of the vehicle.