Starline A96 - Page 24

Сработал тревожныи уровень датчика удара.png
Image not found or type unknown
— on,
Датчик удара отключен.png
Image not found or type unknown
— off.
Volume adjustment is done by short pressing the buttons
icon-short-2.png
Image not found or type unknown
or
icon-short-3.png
Image not found or type unknown
, respectively. A short press of the button
icon-short-4.png
Image not found or type unknown
enables or
disables the vibration signal.
To switch to adjusting the next type of signal within the selected sound profile, press
icon-short-1.png
Image not found or type unknown
.
Exiting the menu automatically occurs after 10 seconds without pressing any buttons on the
remote. After exiting, the name of the set profile will be displayed on the screen for several
seconds:
image.png
Image not found or type unknown
Resetting Profile Settings to Factory
Defaults
To reset profile settings to factory defaults, follow these steps:
1. Select the desired sound profile using the corresponding button combination.
2. Enter the sound profile menu by second-level long press of the 3 button:
icon-long-3.png
Image not found or type unknown
icon-note-2.png
Image not found or type unknown
.
3. Repeat the second-level long press of the 3 button:
icon-long-3.png
Image not found or type unknown
icon-note-1.png
Image not found or type unknown
icon-note-1.png
Image not found or type unknown
.
Selecting a Sound Theme
In the sound profile menu, you can also set the tone of the remote key's sound signals by selecting
one of the sound themes. To select a sound theme, follow these steps:
1. Enter the sound profile menu by performing a second-level long press on button 3:
icon-long-3.png
Image not found or type unknown
icon-note-2.png
Image not found or type unknown
.
2. Briefly press buttons
icon-short-double-2-3.png
Image not found or type unknown
simultaneously. The screen will
display the name of the sound theme: BR-1 or BR-2.
3. Briefly press buttons
icon-short-double-2-3.png
Image not found or type unknown
simultaneously to select the next
sound theme.
You will automatically exit the menu after 10 seconds if no buttons on the remote key are pressed
By default, the BR-1 theme is set