Entering the device registration mode
using the transceiver button
1. Set the system to "Disarmed" mode.
6.png
Image not found or type unknown
2. Turn off the ignition (if it was on).
7.png
Image not found or type unknown
3. Press the transceiver button 7 times.
n_Кнопка-трансивера_2.png
Image not found or type unknown
4. Turn on the ignition. There will be 7 flashes of the transceiver LED and 7 audible signals.
9.png
Image not found or type unknown
5. Entry into the registration mode will be confirmed by 2 flashes of the transceiver LED and
2 audible signals.
n_Светодиод трансивера.png
Image not found or type unknown
Registration of primary and additional
remote keys
1. Press buttons 1 and 2 of the remote key briefly.
n_Кнопка 1 _Кнопка 2.png
Image not found or type unknown
2. After 3 seconds, successful registration will be confirmed by a short sound signal from the
remote key, 2 flashes of the service button or transceiver LED, and 2 sound signals. If the
remote key is not registered, the remote key will emit 4 sound signals.
3. Perform steps 1 and 2 for each remote key.
Registration of tags
1. Remove the power element from the tag.
12.png
Image not found or type unknown
2. Press and hold the tag button and insert the power element. The LED of the tag will light
up red.
13.png
Image not found or type unknown
3. Release the button and monitor the series of red flashes for 10 seconds.
14.png
Image not found or type unknown
4. Successful registration will be confirmed by a green flash, 2 flashes of the LED on the
transceiver, and 2 sound signals. If the tag is not registered, the LED of the tag will remain
red.
n_Кнопка-трансивера-и-метка_2.png
Image not found or type unknown
5. Repeat steps 1-3 for the remaining tags.
To Next Page
Loading...
