Starline E96BT - Alarm Mode; Panic Mode; Slave Mode

StarLine E96, E66
22
«Alarm» mode
The «Alarm» mode is activated at violation of any zone in the «Security
on» mode. The system will switch on sound alerting by the horn and
light emergency alarm for 30 seconds and will notify the owner to remote
key. If the zone is not restored, the system will repeat the alarm cycle
once more.
If a warning zone is violated, 6 light signals and 3 long horn signals
will follow.
The «Alarm» mode is reset without security deactivation by a short
pressing on remote key button
1
or
2
.
ATTENTION! The maximum number of zone actuations is
limited to 8 repetitions per 1 security cycle.
«Panic» mode
The «Panic» mode is intended to ensure safety of the owner and car.
This mode is activated by owner’s command by a double pressing
on remote key button
1 1
or SMS-command 19 (available in
connection with StarLine M66 tracking device). Upon command
reception the system activates sound alerting by the horn and
emergency light alarm for 10 seconds to attract the attention of nearby
persons.
«Slave» mode
The «Slave» mode allows for system control by means of the original
alarm remote key.
While disarming in this mode dditional owner authorization by presence of the tag or
LCD remote key is used. At deactivation of standard alarm security, the
system checks presence of the tag in the identication zone. If the
tag is found, car security is deactivated.
If the tag (remote key) is not found within 10 seconds, the system will
set to the «Alarm» mode.