Starline E96BT - Change of Owner Authorisation Code

short user manual
37
Change of owner authorization code
The owner code is used for user authorization by means of the
standard car buttons.
Do as follows to change the owner authorization code:
1) Deactivate the system security.
2) Switch o ignition (if it is on).
3) Press the service button 7 times.
4) Switch on the ignition. 7 light signals of the LED
on the service button will follow. Entry in the
registration mode will be conrmed by 2 short
signals of the LED on the service button.
5) Enter a new owner authorization code using
the standard car buttons with pressing interval
not more than 3 seconds. Each pressing of the
standard button will be accompanied with a
single light signal on the service button.