Starline E96BT - Function Turbotimer

StarLine E96, E66
28
The starting preheater can be switched o by successive pressing of
remote key buttons
2
2
.
Automatic mode
The automatic mode is activated by the installation specialist
during system setting after mounting.
In the automatic mode the starting preheater is switched on before
operation of engine remote and/or automatic starting. If engine
temperature before remote or automatic starting is less than specied,
the starting preheater will be started. The engine will be started after
engine warm-up to the preset temperature (during automatic starting)
or upon expiry of the preset time.
The starting preheater is switched o upon expiry of the specied time
or reaching of the switch-o temperature threshold.
Time of preheater operation in this mode is 10 minutes. Operation can
be prolonged by manual sending of a repeated command for starting
preheater switch-on.
Operation time and switch-o temperature threshold of the starting
preheater can be changed in the personal account on the website
starline.online or in the StarLine mobile application.
Function «Turbotimer»
Use the function «Turbotimer» for turbocharged cars for engine
turbine cooling.
The «Turbotimer» function is activated by a installer during
installation.
Activate the function as follows:
• apply the parking brake with the engine operating. The LED on
the valet button will light up;
• take the key out of the ignition lock. The engine will continue
operating;