Starline E96BT - Drive Prohibition Function; Engine Starting Function

StarLine E96, E66
24
• in the remote key’s cursor menu by selecting the corresponding
item;
• holding of the tag button for 5 seconds.
«Drive prohibition» function
Use of the «Drive prohibition» function prohibits driving without
additional owner identication.
Additional authorization is performed by entering the code of owner
authorization using the standard car buttons (for instance, the
multimedia control buttons on the steering wheel, window raiser
control buttons) at each security deactivation. The code is entered
with the ignition switched-o.
If the owner authorization code is not entered, then if an attempt at
driving is made, the engine will be blocked for 1 minute or until entry
of the owner authorization code
«Engine starting» function (only for StarLine E96)
The starting function allows for remote and automatic car engine
starting/stopping.
Preparation of a car with manual transmission for remote and
automatic engine starting.
Before engine starting, perform the procedure «program neutral»:
• apply the parking brake with the engine operating. The LED on
the service button will light up;
• take the key out of the ignition lock. The engine will continue
operating;
• leave the car, close the doors, trunk, hood and send the “Security
activation” command. The engine will be stopped;
• the system will set to the security mode;
• the «N» pictogram will appear on the remote key;
• the system is ready for remote and automatic engine starting.