user manual
37
30 sec 30 sec
< 30 km/h
2. Anti-hijack operation sequence when speed from CAN bus is not
supported:
• any of secured zones has been breached (doors, hood or trunk)
• motions sensor has triggered
• in 30 sec system begins seeking for a tag or remote key
• in another 30 sec, if a tag or remote key has not been detected,
system enables warning sound and lights for 10 sec
• engine will be stopped in 3 min or at brake pedal pressing.
Exit from Anti-hijack mode by a tag or remote key loss is made by one of
following ways:
• when tag or remote key is detected in range
• entering emergency disarm code with service button or external
transceiver button
In case of invalid emergency disarm code is entered 3 times,
then a code entry will be blocked for 15 min.
Slave mode
Slave mode allows to control security system by means of a factory
remote control or Keyless-Go system.
System detects unlocking doors and disarming factory security and waits
for owner authorization with any of below methods before disarming
itself:
Waiting for authorization starts at any of door, hood and trunk
open.
To Next Page
Loading...
