user manual
51
Owner authorization code (PIN-to-Drive)
Pin-to-Drive code entered with factory buttons is used for secondary
owner authorization at disarming and immobilizer mode.
Recording and changing authorization PIN code in registration mode:
1) Disarm system if it is armed.
2) Switch ignition O if it is On.
3) Push service button or external transceiver
button 7 times.
4) Switch ignition On. 7 LED ashes and 7 beep
sounds shall follow.
5) Entry into registration mode will be conrmed
with 2 LED ashes and 2 beep sounds.
6) Enter a new PIN code with use of supported
factory buttons with 3 sec and less intervals.
Each pushing will be indicated with one LED
ash.
To Next Page
Loading...
