StarLine E9 v2
52
Authorization PIN code may consist of 2 to 25 push sequence of
factory buttons. List of supported factory buttons is published
at can.starline.ru for each supported vehicle. If pushing a button
is not indicated with a LED ash, then this button is not
supported via CAN bus.
7) Code entry will be conrmed in 3 sec with 2
LED ashes and 2 beep sounds.
8) Enter a new PIN code once again.
9) Properly repeated new code entry will be
conrmed with 2 LED ashes and 2 beep
sounds. Invalid code entry is followed with
4 LED ashes and 4 sounds, then repeat 5...8
steps.
10) Switch ignition O within 10 sec to exit
registration mode.
11) Exit from registration mode will be
conrmed with 2 LED ashes and 2 beep
sounds.
To Next Page
Loading...
