Starline E9v2 - Page 56

StarLine E9 v2
56
Changing emergency disarm code with
service button (or external transceiver
button)
1. Switch system in disarmed mode if it is armed.
2. Push service button 4 times.
3. Switch ignition On. 4 LED ashes and 4 sounds shall follow.
4. Entry into code recording will be conrmed with 2 LED ashes and 2
sounds.
If nothing is done withing 5 sec system shall turn O emergency
code recording mode.
5. Switch ignition O.
6. Switch ignition On and push service button a number of times equal to
a rst digit of existing emergency disarm code.
7. Switch ignition O. Each digit entry will be conrmed with LED
ashes equal to a sequence number of corresponding digit entered
(1,2, 3 or 4 times).
8. Repeat 6...7 steps for remaining digits.
9. Valid existing code entry will be conrmed with 2 LED ashes and 2
beep sounds.
10. Switch ignition On. Push service button a number of times equal to a
rst digit of a new emergency disarm code.
11. Switch ignition O. Each digit entry will be conrmed with LED
ashes equal to a sequence number of corresponding digit entered
(1,2, 3 or 4 times).
12. Repeat 10...12 steps for remaining new code digits.
13. A new code entry will be conrmed with 2 LED ashes and 2 beep
sounds.
14. Enter a new code once again repeating 10...12 steps.
15. New emergency disarm code recording will be conrmed with 2 LED
ashes and 2 beep sounds.