3.7 Setting alarm thickness limits
The instrument will alarm if the measurement is out of limits. When the
measurement is lower than the low limit or higher than the high limit, the
buzzer will alarm. The alarming limit is set as follows:
1) Press , move cursor to ALARM.
2) Press display the low and high limit of previous setting, use or
to set the new low or high limit.
3) To exit the Limit Setting, press , , or start to measure.
3.8 Menu option
The setting and function of the instrument be handle in Menu option.
Press ,, move cursor to MENU then Press display main menu.
3.8.1 System Setup
1)
To Next Page
Loading...
