Statesman STUDIO2B - LPG Conversion

12
LPG Conversion
This cooker has been pre-set for use on Natural Gas. A conversion kit is included for
converting the appliance for use on LP Gas. This should only be carried out by a suitably
qualied engineer.
CHANGING THE INJECTORS
Refer to the table of injector sizes to select the correct injectors. The hotplate injectors
are situated underneath the hotplate caps. To access the oven and grill injectors,
proceed as follows:
1. Remove the outer back panel. Unscrew the gas supply tube nut from the injector block.
2. Remove the oven base panel inside the oven.
3. Remove the 2 screws at the rear, either side of the oven burner to release the
oven injector block behind.
4. Replace the injector with the relevant LPG one and re-t the injector block.
5. Remove the grill burner by undoing the screw at the front of the burner.
6. Exchange the injector without removing the injector block and re-t the grill burner.