Statesman XD0806WE - OPERATING YOUR WASHER DRYER; Initial Setup and Calibration; Before and During Washing

10
OPERATING INSTRUCTIONS
CAUTION!
Before washing, please make sure the appliance is installed properly.
Before washing for the rst time, the washer dryer should be run on any program for a full cycle
without any clothes in.
Calibration
It’s recommended to calibrate the washer dryer:
1. Empty the washer dryer
2. Plug in
3. Power on the washer dryer and press “Delay” and “Temp.” at the same time for 10 seconds. The
display will show “t19”
4. Press to start the wash machine and wait till display shows “****”
1. Before Washing
Main
wash
Softener
Prewash
Plug in Open tap Load Close door Add detergent
NOTE: Detergent need to be added in “case I” after selecting the pre-wash function.
2. Washing
Power on Select program Select function
or default
Start up
NOTE:
If default is selected, step 3 can be skipped.
The function button line chart is for reference only, please refer to real product as standard.