7
Installation Area
WARNING!
Stability is important to prevent the product from moving!
Make sure that the product isn’t standing on the power cord.
Before installing the machine, ensure it is in the following location:
1. Rigid, dry, and level surface
2. Avoid direct sunlight
3. Sucient ventilation
4. Room temperature is above 0°C
5. Keep far away from the heat sources such as coal or gas.
Unpacking The Washing Machine
WARNING!
Packaging material (e.g. Films, Styrofoam) can be dangerous for
children.
There is a risk of suocation! Keep all packaging well away from
children.
1. Remove the cardboard box and styrofoam packing.
2. Lift the washer dryer and remove the base packing. Make sure the small
triangle foam is removed with the bottom one together. If not, lay the
unit down on its side, then remove the small foam from the unit bottom
manually.
3. Remove the tape securing the power supply cord and drain hose.
4. Remove the inlet hose from the drum.
Removing Transport Bolts
INSTALLATION
ww w
w≥20mm
WARNING!
You must remove the transport bolts from the backside before using the product.
You’ll need the transport bolts again if you move the product , so make sure you keep them
in a safe place.
Please take the following steps to remove the bolts:
1. Loosen 4 bolts with spanner and then remove them.
2. Stop the holes with transport hole plugs.
3. Keep the transport bolts properly for future use.
To Next Page
Loading...