8
Raise Lower
Lock Nut
Foot
Leveling The Washer Dryer
WARNING!
The lock nuts on all four feet must be screwed tightly against the housing.
1. Check if the legs are closely attached to the cabinet. If not, please turn them to their original
positions by tightening the nuts.
2. Loosen the lock nut, turn the feet until it contacts with the oor.
3. Adjust the legs and lock them with a spanner, making sure the machine is steady.
Connecting Water Supply Hose
WARNING!
To prevent leakage or water damage, follow the instructions in this chapter!
Do not kink, crush, modify or sever water inlet hose.
For models equipped with a hot valve, connect it to hot water tap with hot water supply hose.
Energy consumption will decrease automatically for some programs.
Connect the inlet pipe as indicated, there are two ways to connect the inlet pipe.
1. Connection between ordinary tap and inlet hose.
5mm
Clamp Nut
Side Bushing
Loosen clamp nut
and four bolts
Tighten clamp nut Press slide bushing,
insert inlet hose into
connecting base
Connection nished
2. Connection between screw tap and inlet hose.
Tap with threads and inlet hose Special tap for washer dryer
Side Bushing
To Next Page
Loading...