Steamfast SF-142 - Microfiber Pads and Carpet Glider

ENGLISH
|
7
MICROFIBER PADS
1. Lay one Microber Pad on at surface, with fastener strips facing upward.
2. Align Mop Head above Microber Pad. Make sure Mop is oriented with Pad as shown, and
centered as best as possible (FIGURE 2-A).
3. Press Mop Head rmly down onto Microber Pad. Fastener strips will adhere to Pad Grips on
underside of Mop. Pad should now be attached and ready for use (FIGURE 2-B).
4. To remove, use your foot to press down on Microber Pad release tab while simultaneously
pulling Mop Head up off of Pad.
CAUTION: Use care when handling a recently used Microber Pad, as it may still be hot.
NOTE: Microber Pads are machine washable. To avoid picking up lint, washing
separately from other fabrics is recommended. Only use liquid detergent. Avoid using
any fabric softeners or bleach. Air drying is recommended; machine drying on a low
setting is acceptable as well.
CARPET GLIDER
NOTE: Microber Pad should already be connected to Mop
Head before using Carpet Glider.
1. Lay Carpet Glider on at surface.
2. Align Mop Head above Carpet Glider. Make sure Mop Head
is oriented with Carpet Glider as shown (FIGURE 3).
3. Set Mop Head down in Carpet Glider.
NOTE: Carpet Glider does not connect to Mop Head.
The Mop Head/Microber Pad simply rest inside the
Carpet Glider as it is pushed along carpet, until they are
lifted out.
FIGURE 3
FIGURE 2
2-B2-A