Steelcase Migration SE - Page 17

Errors and malfunctions
_______________________________________________________________
153310 17
Table of error messages with the Memory control panel
Signal/Code
Message
Required measure(s)
1
Firmware error
Disconnect the power supply from the
power supply line.
Then disconnect the system from the
power supply.
Re-connect the DM system and use it
as usual.
2
Overcurrent with motor
Release all buttons and wait 5 seconds.
Then try again.
Signal/Code
Message
Required measure(s)
HOT
The overheating protection circuit has
been activated.
Wait until the overheated components have cooled down.
ISP
The system has detected a collision.
Release all buttons and wait until the drive back function
process is completed.
CON followed by
ERR
The system has detected a connection
error.
Release all buttons and wait 5 seconds. Then try again.
Disconnect the power supply from the power supply line.
Then disconnect the system from the power supply. Re-
connect the DM system and use it as usual.
ERR followed by
ERROR NUMBER
An internal error has occurred.
Read the table below to determine the correct corrective
measure for the indicated error code.