Steepletone BRITANNIA - LISTENING TO DAB RADIO; Digital Audio Broadcasting; FACTORY RESET; TURNTABLE OPERATION

7
Notes:
 Thesystemallows5secondstostarttheprogrammingprocedure–ifafter5secondsprogramminghasnotstarted,theunit
willautomaticallyresumenormalTunermode.
 Youcanoverwriteacurrentstationbystoringanotherfrequencyinitsplace.
 Thepre‐setmemorieswillbecancelled
completelyiftheunitisdisconnectedfromthemainspower.

FM&FM‐STEREORECEPTION
 TAPandholdtheMEUN/INFObutton(5)for2secondsandtheLCDdisplaywillshow“AUDIOSETTING”.
 TAPSCAN/ENTERbutton(6)andthenTAPTUNEdown“‐“orup“+”button(9)toselecteitherSTEREOorMONOmode.TAP
theSCAN/ENTERbutton(6)againtoconfirm
thesetting.
 Ifstereosignalsareparticularlyweak,itispreferabletoreceivetheFMprogrammeinMonosound.
 Ifastereosignalreceived,theStereoindicator“”willappearontheLCDdisplaytoshowtheradioisnowreceivingan
FMprogr ammeinstereosound.

HINTSFORBESTRECEPTION
- FM : the receiver work with detachable DAB/FM wire antenna, make sure the antenna is plugged into the antenna socket (42)
and place it on proper location for the best reception.

LISTENINGTODABRADIO
Digitalaudiobroadcasting(DAB)radio
1. SwitchPowerswitch(50)toPowerontheunit.
2. TAPtheHOMEbutton(13)toselectDABmode,theunitwillautoscantheDABradiostations.
3. TunetotherequiredstationbyTAPingtheTUNEdown“‐”orup“+”button
(9).

FACTORYRESET
Youcanclearalltheradiopresetstationsbyresetingtheunit.
1. SetinDABmode.
2. AftertheunithasautoscantheDABradiostations,thedisplaywillshow<STATIONSCAN>.
3. TAPtheSkipup  button(9)untilthedisplayshows<SYSTEM>.TAPSCAN/ENTERbutton(6)
toenterthesetting.
4. Then the display will show <TIME SETUP>. TAP Skip up  button (9) and the display will show <FACTORY RESET>. TAP
SCAN/ENTERbutton(6)toenterthesetting.
5. Thedisplaywillshow<NO>YES.TAPSkipup  button(9)toselect<YES>andTAPSCAN/ENTER
button(6)toconfirm.
6. Theunitwillberesetandthestoredradiostationswillbecleared.

TURNTABLEOPERATION
BeforePlayingaRecord…
Thisproducthasaflip‐overstylus,whichhastwodiff erentneedlesbuiltintooneStylusHolder,so 
beforeplayingarecord,selectthecorrectneedleforthecorrectRPM/sizerecord(‘78’fora78rpm
record or ‘LP’ for 33
1
/
3
 & 45rpm records should be visible, whichever is applicable).To do so,
first remove the white Stylus Protector/cover by pulling it gently off the Stylus Holder and
Cartridge and towards you (keep this for future use to protect the Stylus when not using the
RecordPlayer),thenpushthewhite
‘handle’downandovertotheotherside.

IMPORTANTNOTE:  PhonoandAuxaresharingthesamefunctionband.Oncethe3.5mmAux‐injack(17)isbeingconnected,
unitwillswitchtoAux‐infunctionautomatically.Therefore,makesurethe3.5mmAux‐injack(17)isnotbeingconnectedifyou
wishtoplayarecord.

PLAYINGARECORD
1. TurnthePoweronwiththeON/OFFswitch(50).
2. TAPthePHONO/AUXFunctionbutton(24)toenterthePhono(Turntable)function.
3. Ensure that the Tone Arm Clip has been pushed up and over to the right to release the Tone Arm before
operating(re‐securetheToneArmafterplayingandbeforemovingtheunittoadifferentlocation).
4. FliptheStylus Holderhandledown andovertoselecteitherthe“LP” or“78”setting,depending on thetypeof
recordtobeplayed.
5. SettheSpeedSelectorSwitch(37)tothecorrectsetting,dependingon
therecordtobeplayed(33
1
/
3
/45/78rpm).
6. Placearecordontheturntableplatter‐usethe45rpmspindleadaptor(36)ifnecessary.
7. Lift the tone arm from the arm rest and move it slowly to the edge of the record‐the turntable will start
rotating‐thengentlyplacethetonearmonthedesiredposition
ontherecord.
8. AdjustthevolumelevelbyturningtheVOLUMEcontrolonthefrontpanel(23).
9. AdjustthespeedwiththePITCHCONTROLknob‐ifrequired(39).*Seesectionbelowonhowtodothis.
10. Whentherecordhasstoppedplaying,theturntablewillautomaticallystoprotating‐unlesstheAUTO‐STOPswitch(38)has
beenswitchedtoOFF–refertotheTURNTABLEAUTO‐STOPFUNCTIONsectioninthemainManual.