current water temperature and the desired water temperature, it can take several
days until the desired water temperature is reached.
•
If do not use the pool for more than a week, shut off the heat pump or reduce the set
water temperature.
•
Do not use the heat pump when the ambient temperature falls below 5 °C.
•
Use the timer (see "Operation" section) instead of running the heat pump
continuously in operating mode.
•
Cover the pool to prevent heat loss due to wind.
Temperature sensors
The heat pump has four temperature sensors that measure the following temperatures with an accuracy
of ±3 °C:
- (14) current water temperature
-
(15) ambient temperature
-
(16) temperature of the compressor in the finned heat exchanger
- (17) temperature of the condenser in the finned heat exchanger
The temperature display can be called up during the operating mode and shows the temperatures
measured by the temperature sensors.
Active display elements:
-
The Heating indicator
or the Cooling indicator
is lit.
-
The Temperature 2 display
shows the set water temperature in °C.
-
The Temperature 1 display
shows the selected temperature sensor (14 – 17).
•
Note: (18) can be selected, but is not in use
-
The SET/TEMP indicator
is lit.
41
To Next Page
Loading...
