2. Push the top part
onto the boom
part
unl it has snapped into place
on both sides.
The lter unit is inserted.
Placing the device in the pool
CAUTION!
Risk of injury!
The device can hurt persons in the pool.
- Make sure no one is in the pool while the device is in the water.
NOTICE!
A lawnmower can damage a cable placed on the ground.
-
Route the cable so that it cannot be damaged by a lawnmower or
similar device.
1. Completely unroll the oang cable
and place it next to the pool without twisng.
2. Hold the device by the handle
and
lower it slowly and lted slightly
forward into the water unl sucient
air has escaped and it sinks to the
boom. Slowly feed the oang
cable
to control lowering. The
device should run at a right angle to
the pool wall.
The device is in the pool.
38