Steinbach Poolrunner S63 - Storage; Troubleshooting

3. Thoroughly rinse the lter unit with
plain tap water.
4. Rinse the device and the oang cable
aer each use with plain tap water
inside and out.
The device is clean.
Storage
1. Thoroughly clean the device (see secon "Cleaning").
2. Let all parts dry completely.
3. Then store the device and its accessories in a dry and frost-free place (≥ +5 °C)
without direct sunlight.
Troubleshooting
Fault descripon Cause Remedy
The cable is twisted or tangled. The device turns in the water
during cleaning (this is
normal).
Switch o the device,
disconnect the cable and
untangle it.
There are obstacles in the
pool.
Remove the obstacles.
The cable in the water is too
long.
Pull the excess cable length out
of the water. The cable in the
water should only be long
enough so that the device can
reach all spots in the pool.
The device cannot reach all
spots.
The nozzle seng is not
suitable.
Change the seng of the
nozzles.
The cable is too short. Let a sucient length of cable
into the pool so that the device
can reach all spots in the pool.
Observe the minimum
distance of the control unit to
the pool.
The water circulaon of the
pool is switched on.
Switch o the lter system of
the pool.
15
43
en