Steinbach Poolrunner S63 - Page 44

Fault descripon Cause Remedy
The device does not funcon. The control unit is not
completely plugged in.
Check the plug connecon of
the power cable and the
control unit.
The control unit needs a
dierent voltage than the local
one.
Contact customer service.
Too much air in the housing. Switch o the device and let all
the air escape.
There are foreign objects in
the drive.
Contact customer service.
The device does not funcon
and all indicators are lit.
The device has a fault. Contact customer service.
The device does not sink. There is air in the device. Switch o the device and let all
the air escape.
The device does not clean
opmally.
The device swirls up dirt and
does not clean suciently.
Change the seng of the
nozzles.
The device oats up or turns in
a circle on the boom of the
pool.
Too much air in the housing. Let all air escape.
The salt content is too high
and the device has more
buoyancy.
Set the correct salt content.
See secon "Technical data".
If the problem cannot be solved, contact the customer service listed on the last page.
44