Steinbach Poolrunner S63 - Lifting the device out of the pool

Disconnecting the control unit
WARNING!
Risk of electric shock!
Handling the power plug with wet hands can lead to an electric
shock.
- Never touch the power plug with wet hands.
1. Disconnect the power plug from the grounded socket.
2. Undo the screw ng of the plug on
the control unit
5
and pull of the
oang cable
1
.
The control unit is disconnected.
Lifting the device out of the pool
WARNING!
Risk of electric shock!
Risk of electric shock if the control unit drops into the lled pool
while it is connected to the power supply.
- Pull the power plug out of the socket before liing the device out
of the pool.
1. Slowly pull the device by the oang cable
1
towards the water surface unl you
can reach the handle
8
.
2. Slowly li the device out of the water by the handle
8
and hold it above the water
surface for 10 to 15 seconds so that most of the water can ow back into the pool.
3. Set down the device next to the pool.
The device is lied out of the pool.
Clean the device aer each use to ensure connued fault-free operaon.
12
5
1
41
en