Need help?Do you have a question about the Stenner Pumps 45MHP10 Series and is the answer not in the manual?
General| Model | 45MHP10 Series |
|---|---|
| Pump Head Material | Polypropylene |
| Type | Peristaltic Pump |
| Maximum Pressure | 100 PSI |
| Power Supply | 115/230V AC, 50/60 Hz |
| Diaphragm Material | N/A (Peristaltic pump - no diaphragm) |
| Pressure Rating | 100 PSI |
Covers warranty period, exclusions, and limitations for Stenner pump products.
Covers electrical, chemical, fire hazards, and appliance use restrictions.
Provides crucial safety guidelines for pump installation, including PPE and compliance with codes.
Addresses common motor problems like noise, failure to run, overheating, and gear stripping with causes and solutions.
Covers problems with adjustment rings, output changes, and indexing, providing corrective actions.
Details issues like cracking, leaking, no/low output, and high output, with causes and solutions.
Addresses tube leaking, shortened life, connection leaks, and provides solutions.
Warns about chemical exposure, pinch points, and pressure hazards during tube replacement.
Provides visual step-by-step instructions for safely removing the pump tube.
Provides visual step-by-step instructions for installing a new pump tube and centering it.
Covers safety precautions, preparation, and the procedure for removing the pump tube.
Details installing the new tube and expanding the roller assembly for proper fit.
Describes the final steps to center the new tube within the pump head for correct operation.
Highlights hazards like pressure, chemical exposure, and the need for PPE during injection point cleaning.
To Next Page