SWM 5000
14
5. The instrument returns to the standby mode
MODE 6: DATE / TIME
Date (including leap years) and time (24h format) are controlled by a
built-in clock. Time is always displayed in the middle of the status line. As
long as a battery is installed, the clock continues to run. Without battery
(for example, when changing batteries) the power reserve lasts for about
10 minutes. After that the clock has to be reset.
1. Select with SELECT or continue with MODE 7
2. Set the day DD with "+ / -" and confirm with OK
3. Set the month MM with "+ / -" and confirm with OK
4. Set the year YY with "+ / -" and confirm with OK
5. Set the hour HH with "+ / -" and confirm with OK
6. Set the minutes MM with "+ / -" and confirm with OK
MODE 7: CONTINUOUS OPERATION / TIME OPERATION
In continuous mode, the instrument remains switched on, while in the
time mode, it automatically switches off 30s after switch on. Selected
mode will be saved.
1. Select with SELECT or continue with MODE 8
2. With current time mode, CONTINUOUS OPERATION is
displayed. Select with SELECT. The instrument immediately
returns to the standby position
3. With current continuous mode, TIME OPERATION is displayed.
Select with SELECT. The instrument immediately returns to the
standby position
MODE 8: LANGUAGE / SPRACHE
You can choose between German, English and Russian.
1. Select with SELECT or go back to MODE 1
2. Select the language with "+/-" and confirm with OK
The time below will be set
after the final OK
Position to be set flashes !
To Next Page
Loading...