SSD10000S - SSD10000S/3PH
10
Stephill generators must not be used in a flammable environment.
Operation of the machine in a saline environment will require additional corrosion protection.
All Stephill generators comply with current EEC directives including:
2016/1628/EU Non-Road Mobile Machinery (NRMM).
2014/30/EU The Electromagnetic Compatibility Directive.
2006/42/EC The Machinery Directive.
2000/14/EC Noise emission in the environment by equipment for use outdoors.
2011/65/EU The Restriction of Hazardous Substances Directive.
Reference Relative Humidity
Reference Barometric Pressure
The standard reference condition for relative humidity is 30%. Above this value the rated power must be
reduced.
New oil presents no hazard following short term exposure. Lubricants in particular used engine oil,
are potentially carcinogenic. Direct contact should always be avoided by wearing suitable rubber
gloves when handling them. Used oil should not be allowed to contact the skin. If this does occur,
wash off quickly with a proprietary hand cleanser.
The standard reference condition for total barometric pressure is 1 bar. This corresponds to an altitude of
approximately 100m. Above 100m the rated power must be reduced.
Where mechanical assistance is used in lifting machines, ensure the lifting eye is used, and that all
components used to lift the machine are within their Safe Working Load (SWL).
The integral lifting beam and associated lifting eye on the generator should be regularly checked for signs of
damage or gross corrosion.
All nuts and bolts associated with the lifting beam and eye should be regularly checked for tightness and
corrosion.
Fuels and lubricants are a potential source of fire. Be careful not to spill fuel, clean up any spillages.
Inhalation or swallowing of diesel should be avoided. If in doubt seek medical advice. All other forms of
contact are an irritant and therefore should also be avoided. If skin contact is made wash with soap and
water.
To Next Page
Loading...
