Stephill SSD10000S - Check Oil Level - How to; Adding Engine Oil

SSD10000S - SSD10000S/3PH
13
It is recommended to check the oil level BEFORE EVERY START OPERATION - Ref. Fig.5
Ensure the generator (engine) is on level ground to ensure the correct oil quantity is measured.
● Check the engine oil level before starting or more than 5 minutes after stopping the engine.
● Remove the oil level gauge, wipe it clean and reinstall it.
● Take the oil level gauge out again, and check the oil level.
(1) Oil filler plug
(2) Oil level gauge (A) Ensure the engine oil level within this range
Fig.5
Adding Engine Oil
Refer to engine owners handbook supplied with each generator for oil specification, viscosity and typical
capacity. Alternatively navigate to the Service section at
Check Oil Level - How To
Fig.5 shows the oil fill and oil dipstick locations for the Kubota D722 engine used on the Stephill SSD10000S
generators.
Add oil If the level is low. Do fill past the high mark on the dipstick (2). WARNING - Never overfill the engine
with oil. Engine damage can occur.
www.stephill-generators.co.uk