EasyManua.ls Logo

Stephill SSD6000 - Fuel, Oil, and Lifting Safety; Operational Safety and Storage

Stephill SSD6000
21 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Issue 6 10 15/06/2015
8 SERVICE AND MAINTAINENCE
IMPORTANT WARNING:
After any service on the generator, ensure that all piping and electrical cables are correctly
routed and secured away from hot parts. Failure to observe this warning may result in
damage to the piping and cables which could result in a fire.
Do not service or work on generator whilst the engine is running. Always disconnect
battery prior to working on engine or alternator.
8.1 Engine service
Service the engine strictly in accordance with the instructions given in the relevant
operator manual / handbook. An approved specialist must carry out any maintenance.
Any spare parts required should be of genuine manufacturer’s origin. Note: failure to
adhere to manufacturer’s recommended service schedules may invalidate the warranty.
Please consult engine operator’s manual for full service intervals.
8.2 Alternator service
Brushless alternators employed on Stephill Generators are maintenance free. Service
must be carried out by competent qualified personnel strictly in accordance with the
instructions given in the handbook. Any spare parts required should be of genuine
manufacturer’s origin.
9 Alternator spares
Part No
Alternator
Description
028-0026
NSM
Diode
037-0019
NSM
Capacitor - 35µf
10 Yanmar consumable spares
Part No
Description
029-0007
Air filter
029-0032
Oil filter
11 Spares (general)
Part No
Description
Qty
028-0036
Alternator NSM
1
029-0022
Engine L100
1
039-0015
Engine wiring loom
1
027-0013
Engine mount
2
027-0014
Alternator mount
2
027-0022
Wheel
2
027-0023
Wheel cap
2
022-1012
Filler cap
1
022-1003
50mm Fuel tank gasket
1
022-1004
Temperature switch
1
020-0128
Temperature switch plate
1
022-1015
Low fuel switch
1
022-1001
Neoprene door seal
3M
022-1017
Toggle latch strike
2
022-1018
Toggle latch
2
022-1002
Coverstay
1
022-1007
Wing head stud
6
022-1008
Retainer washer (wing head stud)
6
022-1009
Snap in housing (wing head stud)
6
022-1010
Wear washer (wing head stud)
6
018-0054
50mm Grommet
2
022-1021
50mm Air hose
0.5M
055-0006
Hours run meter
1
036-0039
MCB Cover
1

Other manuals for Stephill SSD6000

Related product manuals