2-1
Unpacking Instructions Operator Manual 068032
UNPACKING INSTRUCTIONS
2
IMPORTANT: Report any shipping damage immediately! Inform shipper of any
damages – leave carton intact. Leave the APC chair in the receiving area until
inspection is complete.
Your APC chair has been carefully packaged at our manufacturing plant to
ensure safe shipment to your medical facility. There are several procedures you
must follow to put your new APC chair into service. These procedures only take
a few minutes to complete and are required to ensure proper operation of the
APC chair.
Step 1 – Cut the two bands around the shipping carton.
Step 2 – Remove the top half of the carton and cut one side of the bottom half.
Step 3 – Remove the APC chair from the carton.
Step 4 – Check to see if all features of the stretcher work properly. If all features
work properly, go to step 5. If any of the features of the APC chair do
not work properly, call STERIS for service.
Step 5 – Clean the APC chair using a mild detergent to remove any dirt
accumulated during shipment.
Step 6 – Place the unit into service.
WARNING – LACERATION
HAZARD: When cutting
bands always use a tool
specifically designed for that
purpose. This will help to
avoid personal injuries
frequently incurred when
bands are cut and tension
released.
To Next Page
Loading...
Need help?
General
