6
835.2
PHASE 2: MOUNTING AND PERIPHERAL COMPONENTS
CONSIDERATIONS PRIOR TO MOUNTING
The location of your Sterisil® Ac+ System needs the following considerations:
• Distance to the water supply
• Leave enough slack in tubing to account for mounting configurations
• Accessibility to digital monitors
• UV Light replacement, allow 12” for clearance
• Cartridge clearance
• Distance to the electrical outlets
• Drain location for the brine line
• Placement location for the storage tank
• Type of system mounting device: Slide or Hinged mount
SLIDE MOUNT
The system will come with the slides affixed in the correct
direction for proper maintenance. Please consider the
orientation of the slides and affixing the slide mount to the
wall mounting plate before you start.
Affixing the Slide Mount to the Wall
• Remove the system off of the slide mount.
• Take your slide mounting plate and mark your holes.
• Screw the mounting plate to the wall and ensure it is
level.
Securing the Ac+ to the Slide Mount
• Take the system and line up the rails on the back of the
system plate to the slides on the mounting plate. Slide
the unit until you hear the rails snap into place.
• Verify it is level.
HINGED MOUNT
The system will come with the hinges affixed in the correct
direction for proper maintenance. Please consider the
orientation of the hinges and affix the hinged mount to the
wall mounting plate before you start.
Affixing the Hinged Mount to the Wall
• Remove the System from the mount.
• Take your hinged mounting plate and mark your holes.
• Screw the mounting plate to the wall and ensure it is
level.
Securing the Ac+ to the Hinged Mount
• Take the system hinges and affix them to the side of the
mounting plate. Push to establish a connection.
• Verify it is level.
Back of System with slide rails installed
Back of System with Hinge Plates installed
Front of Sliding Mount Plate
Front of Hinged Mounting Plate
To Next Page
Loading...