INSTALLATION
Installation
10 | CON Premium www.stiebel-eltron-usa.com
11. Installation
11.1 Minimum clearances to hard surfaces
Ý
FP
Ý
FP
Ý
FP
Ý
FP
Ý
FP
ANY HARD SURFACE
FLOOR
D0000074786
11.2 Installing the wall mounting bracket
The heater is intended for wall mounting using the supplied wall
mounting bracket. The heater may only be installed horizontally.
Note
- The wall mounting bracket can be used as a tem-
plate for wall mounting. This ensures sufficient
clearance from the floor.
- Use a level if the floor is uneven or sloping.
aaa
D0000072159
1
3
2
4
ôÝ ôÝ
FP FP
D0000074785
f Unhook the wall mounting bracket from the heater.
f Place the centred wall mounting bracket horizontally on the
floor. Mark holes1 and 2.
f Lift up the wall mounting bracket so that its lower holes
match up with the markings you have just made on the in-
stallation wall.
f Mark holes3 and 4 on the installation wall.
f Drill the holes at the 4markings.
f Secure the wall mounting bracket with suitable fixing mate-
rials (screws, wall anchors). With the vertical slots, you can
compensate for an offset mounting hole.
11.3 Heater installation
D0000074782
1
1 Wall mounting bracket
f Hook the heater onto the bottom tabs of the wall mounting
bracket by the slots in the back of the heater.
f Place the heater in an upright position.
f Secure the heater by pushing it towards the wall until it au-
dibly snaps into place in the two upper springs on the wall
mounting bracket.
D0000074783
2
1
1 Heater
2 Captive locking screws (attached)
3 Secure the heater against unintentional release, using the
supplied captive locking screws on the left- and right-hand
sides of the wall mounting bracket.
11.4 Dismounting the heater
f Loosen the captive locking screws attached to the wall
mounting bracket.
f To release the heater, push down the springs at the top of the
wall mounting bracket.
f Tilt the heater away from the wall and lift it off the bottom
tabs of the wall mounting bracket.
To Next Page
Loading...
