STIEBEL ELTRON DHC 6 XG - Page 15

STIEBEL ELTRON
15
Earth wire
L wire
N wire
- Insert the Earth wire to the terminal
block for earth wire
- See recommended cable size in
technical data table
- Fit a secure connection cable ensure
dimensions are correct.
The unit must be earthed
properly (see circuit diagram
(Fig 8)).
4. Installation Instruction
- A circuit breaker or power control
switch should be installed before the
unit. The size of the circuit breaker must
correspond to the voltage of the heater
(check the size of the circuit breaker in
the Technical Information section).
- Hang the heater on the screws
mounted on the wall, and slide the
heater down into position.
Fig 13
Fig 14 Fig 16
Fig 15