www.stiebel-eltron.com DHE | 69
OPERATION
Settings and displays
ENGLISH
Menu Description Selectable display |
setting
Explanations Symbol |
display
P12
Backlighting
Auto | On
You can adjust the display backlight.
- If "Auto" is selected, the backlight is switched on during heating
operation and each time an action is performed. If no action is per-
formed for 30seconds, the backlight is switched off again.
- If you select "On", the backlight will remain on constantly.
P13 Reduce backlighting 100% | 20% ( ) You can select 2levels of brightness for the backlight.
P14
Wireless module
After installation of a wireless module (with or without paired wire-
less remote control) in the appliance, menu item P14 is enabled and
"rc" appears on the programming unit display. You can pair one or
more wireless remote controls; to do so, follow the pairing procedure
on the appliance and the wireless remote control.
Pressing "1" on the appliance for longer than 5seconds starts the
pairing process, which is shown on the programming unit of the ap-
pliance by a progress bar on the display and the operating LED flash-
ing. Start the pairing process on the wireless remote control as de-
scribed in the relevant operating instructions. After successful pairing,
the operating LED on the appliance flashes briefly. An unsuccessful
pairing attempt is automatically terminated after 30seconds.
Pressing "2" on the appliance for longer than 5seconds unpairs all
connected wireless remote controls. During unpairing, "rc0" appears
on the display of the programming unit for 5seconds, then "rc" again.
4.9.3 Deactivating the parameter menu
Exit the menu item by pressing "i" and holding for more than
5seconds. Alternatively: The system exits the menu item au-
tomatically 30seconds after the setting has been completed.
To Next Page
Loading...
Need help?
General
