www.stiebel-eltron.com DHEConnect | DHETouch | 95
INSTALLATION
Installation options
13.12 Pivoting appliance cover
The appliance cover can be turned round for undersink instal-
lation.
D0000053287
Remove the programming unit from the appliance cover by
pressing the locking hooks and removing the programming
unit.
Turn the appliance cover (not the appliance) and refit the
programming unit. Push the programming unit home in par-
allel until all locking tabs engage. When engaging the locking
tabs, apply counter-pressure by pushing against the appli-
ance cover from the inside.
WARNING Electrocution
All 4locking tabs on the programming unit must click into
place. The locking tabs must be complete and undam-
aged. If the programming unit is not inserted correctly,
protection of users against contact with live components
cannot be ensured.
Insert the connecting cable plug of the programming unit
into the PCB (see chapter "Commissioning/ Initial start-up").
Hook the appliance cover in at the bottom. Pivot the appli-
ance cover up to the back panel.
Secure the appliance cover.
Fit the cover on to the appliance cover.
13.13 Operation with preheated water
You can restrict the maximum inlet temperature by installing a
central thermostatic valve.
13.14 Registering the mini wireless remote control
The mini wireless remote control learning can be performed via
the programming unit; see chapter "Settings/ Service/ Wireless/
Connect other wireless subscribers".
However, if the programming unit is used outside of the appliance
(in accessories), open the appliance and perform learning as de-
scribed below for mini wireless remote control learning.
To Next Page
Loading...
Need help?
General
