STIEBEL ELTRON HDB-E 13 AU User Manual

ENGLISH
www.stiebel-eltron.com HDB-E AU | 5
INSTALLATION
Safety
INSTALLATION
7. Safety
Only a qualified contractor should carry out installation, commis-
sioning, maintenance and repair of the appliance.
7.1 General safety instructions
We guarantee trouble-free function and operational reliability only
if original accessories and spare parts intended for the appliance
are used.
!
Material losses
Observe the maximum inlet temperature. Higher temper-
atures may damage the appliance.
7.2 Instructions, standards and regulations
Note
Observe all applicable national and regional regulations
and instructions.
- The protection rating IP 25 (hoseproof) can only be ensured
with a correctly fitted cable grommet.
- The specific electrical resistance of the water must not fall
below that stated on the type plate. In a linked water net-
work, factor in the lowest electrical resistance of the water
(see chapter "Installation/ Specification/ Application areas").
Your water supply utility will advise you of the specific elec-
trical water resistance or conductivity.
8. Appliance description
8.1 Standard delivery
- Wall mounting bracket
- 2 plugs
- 2 extensions
- 2 caps
- 2 tees
- 8 flat gaskets
- Strainer
- Flow limiter
- Plastic profile washer
- Plastic cover
- Plastic connection pieces
- Cover guides
9. Preparations
9.1 Installation site
!
Material losses
Install the appliance in a room free from the risk of frost.
 Always install the appliance vertically and near the draw-off
point.
The appliance is suitable for undersink and oversink installations.
Note
The appliance must be fitted to a wall with sufficient load
bearing capacity.
Undersink installation
26�02�02�1373
1
2
1 Cold water inlet
2 DHW outlet
Oversink installation
26�02�02�1374
12
1 Cold water inlet
2 DHW outlet

STIEBEL ELTRON HDB-E 13 AU Specifications

General

Brand	STIEBEL ELTRON
Model	HDB-E 13 AU
Category	Water Heater
Language	English