STIEBEL ELTRON HM Trend - Connecting External Components; Fitting the Appliance Cap

www.stiebel-eltron.com HM (S)| HM(S) Trend | 13
INSTALLATION
Power supply
If no ASL-HM connector block is used:
D0000069971
1
1 Immersion sensor
 Solder the sensor well provided onto the common return
from the DHW and heating system in the building to the heat
pump.
 Insert the immersion sensor into the sensor well.
 Insulate the pipe in accordance with national and regional
regulations.
If an ASL-HM connector block is used:
 Insert the immersion sensor into the sensor well prefitted in
the ASL-HM.
10.4.3 TAF PT immersion/contact sensor
 When installing a sensor, observe the commissioning in-
structions for the heat pump manager (see chapter “Connect-
ing external components”).
10.4.4 Outside temperature sensor AFPT
 When installing a sensor, observe the commissioning in-
structions for the heat pump manager (see chapter “Connect-
ing external components”).
10.5 Connecting external components
 When installing external components, observe the commis-
sioning instructions for the heat pump manager (see chapter
“Connecting external components”).
10.6 Fitting the appliance cap
 Fit the appliance cap in reverse order to the instructions pro-
vided in chapter “Removing the appliance cap”.
Cable with connector
D0000041465
2
1
1 Connection
2 Connector from the programming unit
 Fit the connector from the programming unit in the control
panel.
!
Material losses
Take care not to pinch the power cable of the program-
ming unit when fitting the appliance cover.
 Arrange the power cable in a loop again and secure
it with the multi-use cable tie provided.