STIEBEL ELTRON HM Trend - INSTALLATION; Safety and regulations; Mounting and clearances

www.stiebel-eltron.com HM (S)| HM(S) Trend | 5
INSTALLATION
Safety
INSTALLATION
7. Safety
Only a qualified contractor should carry out installation, commis-
sioning, maintenance and repair of the appliance.
7.1 General safety instructions
We guarantee trouble-free function and operational reliability only
if original accessories and spare parts intended for the appliance
are used.
7.2 Instructions, standards and regulations
Note
Observe all applicable national and regional regulations
and instructions.
8. Appliance description
8.1 Standard delivery
The following are delivered with the appliance:
- 4 double ended screws with rawl plugs, washers and nuts
- 3TAF PT immersion/contact sensor
- 1 AFPT outside sensor
- Installation template
8.2 Accessories
- Connector block ASL-HM
9. Installation
9.1 General information
Note
We do not recommend installing the appliance in wet
rooms. Wet rooms include rooms used, for example, for
washing or drying clothes.
To protect the appliance against damage it should be transported
to the installation location in its original packaging.
Install the appliance in a suitable location close to the heat pump.
Ensure that the wall structure can bear the weight of the appliance
before securing the appliance to the wall.
The wall on which the appliance is to be mounted must be even.
Once mounted, the appliance cap must seal the appliance without
gaps.
 Use spacer discs to compensate for any unevenness.
!
Material losses
 Always fit the appliance cap when interrupting in-
stallation work for any length of time.
9.2 Removing the appliance cap
HM(S) | HM(S) Trend
D0000041457