16 | PER 18/21/24 www.stiebel-eltron.com
INSTALLATION
Commissioning
10.3 Completing the installation
Open the shut-off valve in the twin connector or the cold
water inlet line.
10.4 Installation of wireless remote control
You can attach the transmitter to the wall using the wall mounting
bracket.
Secure the wall mounting bracket to the wall using the adhe-
sive pad provided or a suitable countersunk screw (∅3mm
or less).
11. Commissioning
WARNING Electrocution
Commissioning must only be carried out by a qualified
contractor in accordance with safety regulations.
11.1 Initial start-up
D0000041617
Open and close all connected draw-off valves several times,
until all air has been purged from the pipework and the
appliance.
Carry out a tightness check.
Activate the safety pressure limiter by firmly pressing the reset
button (the appliance is delivered with the safety pressure
limiter deactivated).
Plug the temperature selector cable plug into the PCB.
Fit the appliance cover, ensuring it clicks into place. Check that
the appliance cover is seated correctly.
Switch the mains power ON.
Check the function of the appliance.
FFB mini wireless remote control
The wireless remote control is registered with the appliance at the
factory. If there is no data communication during commissioning,
carry out the self-learning process as follows:
Use the ECO button to switch to the comfort function "Wireless
remote control (rc)"
Press memory button1 on the appliance (the self-learning
phase is activated, bar graph is shown on display).
Then press a button on the wireless remote control.
Anti-scalding protection
In customer service mode, you can limit the temperature to be-
tween 31 and 60°C.
Appliance handover
Explain the appliance function to users and familiarise them
with its operation.
Make the user aware of potential dangers, especially the risk
of scalding.
Hand over these instructions.
11.2 Recommissioning
Vent the appliance and the cold water inlet line (see chapter "Set-
tings").
See chapter "Commissioning".
12. Shutdown
Isolate all poles of the appliance from the power supply.
Drain the appliance (see chapter "Maintenance").
To Next Page
Loading...
