16 | SNU 5 www.stiebel-eltron.com
INSTALLATION
Safety
INSTALLATION
6. Safety
Only a qualified contractor should carry out installation, commis-
sioning, maintenance and repair of the appliance.
6.1 General safety instructions
We guarantee trouble-free function and operational reliability only
if original accessories and spare parts intended for the appliance
are used.
6.2 Instructions, standards and regulations
Note
Observe all applicable national and regional regulations
and instructions.
7. Appliance description
The open vented (non-pressurised) appliance is only suitable for
undersink installation. The appliance is intended to supply one
draw-off point for heating cold water.
7.1 Standard delivery
Delivered with the appliance:
- Wall mounting bracket
7.2 Accessories
7.2.1 Required accessories
The following taps are available as accessories for open vented
operation:
Mixer taps
- WST, WUT
Mono lever mixer taps
- MEW, MES, MEWC
Sensor tap
- WEN
7.2.2 Further accessories
- Strainer for the "cold water inlet" connection
8. Preparations
Flush the water line thoroughly.
Water installation
A safety valve is not required.
Taps
Sealed taps are not permitted.
Install an open tap.
8.1 Installation site
!
Material losses
Install the appliance in a room free from the risk of frost.
!
Material losses
Mount the appliance on the wall. The wall must have a
sufficient load-bearing capacity.
Note
The appliance is only suitable for undersink installation.
The water connections of the appliance point upwards.
Always install the appliance vertically and near the draw-off point.
820
520-570
85
°C
35
55
65
Eco
D0000033291
850
550-600
85
°C
35
55
65
Eco
D0000033294
To Next Page
Loading...
