Stiga B 26 JA - Startup; Startup from cold; Warm start; Operation

EN - 11
Action Result
Release the throttle
control lever 


.


to the neutral position

return to running idle.
Press the throttle control

the throttle control

.
Press the engine





If any of the results fails to comply
with the following tables, do not use the
machine! Take it to a service centre to
be checked and repaired if necessary.
6.3 STARTUP
IMPORTANT A label (Fig. 2) is placed on the
machine that summarizes the start up main steps.
The label is a quick guide and it does not
replace the procedures specied below.

1. 
2. 

3. 
not touch the ground or other objects.
6.3.1 
A “cold” start of the engine means
starting it after at least 5 minutes from when
it was switched off or after refuelling.
IMPORTANT To prevent distortions, the
drive tube must not be used as a support
for the hand or knee during startup.
IMPORTANT To avoid breaking the starter
cable, do not pull the whole length of it or
let it slide along the edge of the cable guide
hole. Release the starter grip gradually,
to prevent it ying back uncontrollably.
1. 
2. 

3. 



4. only for models with throttle shutter:






5. 

in order not to lose control of the

6. 


7. 

8. Pull the starter grip again until

9. 

10. Let the engine run idle for at least 1

IMPORTANT If the starter grip is pulled
repeatedly with the starter on, it may ood
the engine and make starting dicult. “
If the engine oods (see paragraph 7.6).
6.3.2 Warm start


in points 2 - 3 - 5 - 7 - 8 of the previous procedure.
6.4 OPERATION
NOTE Before tackling a mowing job for the rst
time, get to know the machine, learn the most
suitable cutting techniques, make sure your wear
the harnesses correctly, grip the machine rmly
and make the movements required by the job.


• 


• 



6.4.1 
6.4.1.a Cutting line head
Use ONLY nylon lines. The use of
metal lines, plasticised metal lines and/
or lines that are not suitable for the head
can cause serious injuries and wounds.
Do not use the machine for sweeping,
tilting the cutting line head. The power