6
33. Danger! Ejected objects:
34. Danger! Ejected objects: -
35. Danger! Machine rollover:
36. Danger! Dismemberment:
37. Danger of cutting yourself.
38. Warning!
39. Avoid injuries caused by moving belts:
-
NOTE The images corresponding to the texts
in chapters 3 et seq., can be found on pages iii et
seq. of this manual.
3. UNPACKING AND ASSEMBLY
-
-
IMPORTANT The machine is supplied without
engine oil or fuel. Before starting up the engine,
fill with oil and fuel following the instructions given
in the engine manual.
WARNING! Unpacking and completing
the assembly should be done on a flat and
stable surface, with enough space for mov-
ing the machine and its packaging, always
making use of suitable equipment.
3.1 UNPACKING
-
-
NOTE To avoid damaging the cutting-means
assembly when getting the machine down from
the pallet, take it to the maximum height and be
very careful.
Hydrostatic transmission:
-
-
3.2 ASSEMBLY AND CONNECTING
THE BATTERY (Fig. 3.1)
-
IMPORTANT To prevent the safety device in
the electronic circuit board from cutting in, never
start the engine until the battery is fully charged!
WARNING! Follow the battery manufac-
turer’s instructions regarding safe handling
and disposal.
3.3 FITTING THE DASHBOARD
AND STEERING WHEEL (Fig. 3.2)
To Next Page
Loading...
