11
.
5.4.4 Reverse
IMPORTANT Reverse must only be engaged
when the machine has stopped.
IMPORTANT To proceed in reverse gear with
the cutting means engaged, it is necessary to
press and hold the consent pedal down (see 4.8)
so as not to cause the engine to stop.
Mechanical transmission
-
-
-
Hydrostatic transmission:
5.4.5 Grass cutting (Fig. 5.8)
-
Mechanical transmission
NOTE The fifth gear is just a transfer gear
to be used on the flat.
Hydrostatic transmission
-
WARNING! When cutting on sloping
ground, the forward speed must be reduced
to ensure safe conditions (see 1C 7-8-9 +
5.5).
5.4.6 Emptying the grass catcher
(Fig. 5.8)
NOTE The emptying of the grass catcher can
only be done with the cutting means disengaged,
otherwise the engine stops.
NOTE At times the audible warning may be
heard at the moment of engaging the cutting
means even when the grass catcher has been
emptied. This is due to grass-cuttings left on the
sensor of the micro-switch. To stop the signal,
remove the grass debris, disengage the cutting
means and then immediately engage it again.
5.4.7 Unblocking the collector channel
-
-
To Next Page
Loading...
