To Next PageTo Next Page
Need help?Do you have a question about the Stiga PRO 25 and is the answer not in the manual?
General| Chassis material | Steel |
|---|---|
| Cutting height positions | 5 |
| Cutting height adjustment | Central |
| Engine Type | 4-stroke |
| Wheel Size | Front: 200 mm |
Explains symbols used on the machine and document referencing conventions.
Covers 4WD, hydraulic drive, and articulated steering mechanisms.
Explains the electrical safety system and required verification checks.
Introduces the main controls and their basic functions on the machine.
Covers mechanical and hydraulic implement lifter functions and positions.
Details clutch-parking brake, inhibitor, and driving brake pedal operations.
Covers steering wheel adjustment, throttle control, and choke operation.
Use of ignition, PTO engagement, and hour meter function.
Adjusting cutting height and operating electrical accessories like rear rake/spreader.
Manual movement, seat adjustment, and safety switch functions.
Accessing the engine and the quick-release system for implements.
Lists STIGA accessories for various tasks like mowing, sweeping, and snow clearing.
Instructions for filling the fuel tank safely, including precautions.
Procedure for checking and topping up engine oil before operation.
Covers general and electrical safety checks required before each use.
Step-by-step procedure for starting the engine, including cold/warm starts.
How power steering works and advice for safe operation, including slope use.
Procedures for stopping the engine and cleaning the machine after use.
Overview of service schedule and essential preparation steps for maintenance.
Tyre pressure settings, oil change intervals, and oil specification.
Procedures for replacing engine oil filter and fuel filter.
Checking, draining, and replacing transmission oil and filter.
Checking belts and servicing the steering system, including adjustments.
Covers battery care, charging, removal, and installation procedures.
Maintenance procedures for engine air filters and spark plugs.
Cleaning battery terminals and the engine air intake for cooling.
Lubrication schedule and fuse details for fault diagnosis.
