WORKSHOP MANUAL
Map of functional units
TC 108 SD - TC 118 SD
B) Routine maintenance
– All work carried out in section a), plus:
– Check battery charge
– Check tension of belts
– Adjust brake
– Adjust blade engagement
– Adjust blades brake
– Check steering allowance
– General lubrication
– Check and/or replace the transmission oil
– Clean away grass cuttings and wash exterior
– Clean and wash inside cutting deck
– Touching up of any damaged paint
The Instruction Handbook has a number of
operations to be carried out by the Customer
for a minimum of ba sic maintenance, and oth-
er operations not always within his capacity.
For this reason the Service Centre should un-
dertake to keep the machine in perfect work-
ing order in two ways:
A) Tuning the machine whenever possible.
B) Proposing a regular maintenance pro-
gramme to the Customer to be carried out
at prearranged intervals (for example, at
the end of the summer or prior to a long
period of inactivity).
A) Occasional tuning
– Check working order of safety devices and renew il-
legible or missing labels, following the layout below
– Check tyre pressures
– Clean air lter
– Check engine oil level
– Check for fuel leaks
– Aligning the cutting deck
– Sharpen and balance the blades and check the
condition of the hubs
– Check for wear in the belts
– Check the blade brake engagement
– Grease front wheels lever joint pins and bushes
– Check tightness of engine screws
– Check all those items indicated in the engine man-
ual
– Check the oil level of the transmission
– Check for leaks in the hydraulic system
General informations
In questo capitolo vengono trattati i criteri di in ter
vento per la manutenzione ordinaria.
Related topics
---
CHAPTER REVISION FROM ... PAGE
3.1 0 2018 1 of 1
CRITERIA FOR MAINTENANCE
To Next Page