Stiga TC 108 SD - Accelerator and Carburettor Adjustment

WORKSHOP MANUAL
Map of functional units
TC 108 SD - TC 118 SD
On reassembling, put the accelerator lever in the «MI-
NIMUM» position, connect the end of the cable (2) to
the terminal (3) on the engine after having mo ved the
cursor (5) in the same «MINIMUM» position specic
to each type of engine and shown in the in struc tion
booklet.
When assembly is completed ...
Ret the dashboard.
Remove the dashboard.
Take o the knob (1) and disconnect the cable (2)
from the connection terminal (3) on the engine.
Undo the two xing screws (4) and take out the ac ce-
lerator together with the wire.
General informations

Related topics
[
5.3] Removal of the dashboard
REPLACEMENT OF THE ACCELERATOR AND
ADJUSTMENT OF THE CARBURETTOR
CHAPTER REVISION FROM ... PAGE
6.7 1 2018 1 of 1

 

