EN - 11
hole and turning it so that both the spring
2.
it outside the side discharge chute.
3. Fit the pin ) in the holes on the
and on the side discharge
chute, so that it passes through the coils
of the spring and the drilled end
4. Insert the cotter pin into the hole
) on the pin (and rotate
6.E.1)
pair of pliers), so that it cannot slide out,
causing the pin ) to disengage.
WARNING
ATTENTION
(Fig. 8.B) and lift the side unloading
NOTE
5.6 FITTING OF THE SIDE
REINFORCEMENTS OF THE
CUTTING MEANS ASSEMBLY
5.7 MOUNTING AND COMPLETING
FOR MODELS WITH REAR
1.
2.
3.
4.
5.
6.
full collection bag indicator in
7.
5.8 MOUNTING OF THE GRASS
1. Use the grass catcher open / close
NOTE
button of the grass catcher pressed.
2.
using the right support as a lateral support.
To Next Page
Loading...
