Stihl 029, 039 - Page 16

STIHL 029, 039 16
Top:
Fitting retainer on
Top: clutch shoe Top:
Removing a clutch spring Clutch clamped in a vise
Bottom:
Bottom: Pushing clutch shoe Bottom:
Component parts of clutch onto carrier Attaching clutch springs
- Use assembly hook to remove all Assembling and installing - Clamp the clutch, e.g. one shoe,
the clutch springs. the clutch: in a vise.
- Pull the clutch shoes off the - Slip the retainers onto the clutch - Attach one end of each spring to
carrier. shoes so that the narrow side is the clutch shoes by hand.
next to the series number, e.g.
- Pull the retainers off the clutch 1127. - Use the assembly hook to attach
shoes. the other ends of the springs and
- Fit the clutch shoes over the press them firmly into the clutch
- Clean all parts and stub of arms of the clutch carrier so that shoes with one finger.
crankshaft in white spirit. the series number, e.g. 1127, is
Replace any damaged or worn on the same side as the carrier's
parts. hexagon.